Hand Tools

5/16" Disconnect Tool (for 35800) 35740

Lisle Tools Catalog

Double Ended Trim Remover 35470

Double-ended tool with radius on one end and narrow square tip on the other end. Strong heat-treated alloy steel tool is ideal for prying car interior panels.

Double Ended Clip Lifter 35460

Smaller opening works for lifting the center pin and the wider opening lifts the fastener from the panel. Also works on most plastic fasteners, plastic clips, upholstery or door panels. Zinc finish...

3 Pc. Body Trim Tool Set 35440

Works on GM, Ford and others using common "C" type clip. Upholstery and panel removers are designed for plastic fasteners.

Door Upholstery Removal Tool 35400

Place the tool under the edge of the door panel and insert into fastener as far as possible, then simply pry up. Rugged tool with a large comfortable handle.

Door Panel Removal Tool 35350

Lisle Tools Catalog

V-Groove Clip Remover Tool 35300

The tool is equipped with a sliding urethane bumper for use when extra leverage is necessary. Also use the bumper to protect the vehicle surface.

Plastic Fastener Remover Tool 35260

This tool quickly removes various types of plastic fasteners that hold on weather stripping, radiator shrouds, fender linings, air dams and other plastic or rubber parts. The tool is equipped with a...

Belt Molding Tool 35240

Makes removal of newer belt moldings easy. For clipless moldings, the tool is twisted or pulled back to release the molding from the door tab. For moldings with metal clips, hook the tool under...

Windshield Molding / Door Handle Clip Pliers 35200

Releases clips to remove chrome molding on most windshields and rear glass. Offset handle permits easy access to molding clips. Slips under door handle without damage to panel material.

2 Pc. Pocket Pry Bar 35170

For use when removing seals, electrical connectors, plastic clips, o-rings, plastic caps, interior trim pieces, metal and plastic retainers. The 1/8" and 3/16" square shaft pry bars each have a...

Window Belt Molding Removal Tool 35150

Slide the powder-coated tool downward between the window exterior and the door. The channel side of the tool should face the door. When the tool channel is below the belt molding, push or pull the...