Clarkson-Osborn

13mm TiNC Coated HSS 2 Flute Threaded Shank End Mill MC05630C

HSS Center cutting Bright finish (TiN and TiCN coatings available) Designed for plunge cutting and slotting 2 flute end mills provide increased chip capacity for higher feed rates

13mm TiNC Coated HSS 4 Flute End Mill EM61630C

HSS Center cutting Bright finish (TiN and TiCN coatings available) 4 flute design reduces chip load per tooth, offer greater wear resistance, and improved surface finish Designed for profile,...

13mm TiNC Coated HSS 4 Flute End Mill MC53630C

Cobalt Non-center cutting Bright finish (TiN and TiCN coatings available) Multi-flute design reduces chip load per tooth, offer greater wear resistance, and improved surface finish Designed for...

13mm TiNC Coated HSS 4 Flute Threaded Shank End Mill MC03630C

HSS Non center cutting Threaded shank Bright finish (TiN and TiCN coatings available) Multi-flute design reduces chip load per tooth, has greater wear resistance, and improved surface finish Designed...

13mm x #1 Cobalt Morse Taper Chucking Reamer RE22630

Cobalt Bright and black finish Morse taper shank Right hand cut Left hand helix These reamers can be run approximately 25% faster than regular HSS reamers with increased life due to the cobalt...

13mm x #1 HSS Extra Long Morse Taper Drill Bit DR43630

HSS 118° Degree point Black oxide finish for increased wear resistance and added lubricity Made to fit American standard (Morse) taper shank holders Various overall lengths / flute lengths available...

13mm x #1 HSS Extra Long Morse Taper Drill Bit DR44630

HSS 118° Degree point Black oxide finish for increased wear resistance and added lubricity Made to fit American standard (Morse) taper shank holders Various overall lengths / flute lengths available...

13mm x #1 HSS Morse Taper Drill Bit DR35130

HSS 118° Degree point Black oxide finish for increased wear resistance and added lubricity Made to fit American standard (Morse) taper shank holders Recommended for general purpose use in a wide...

13mm x #1 HSS Morse Taper Machine Reamer RE45630

HSS Bright and black finish Right hand cut Left hand helix Morse taper shank Left hand spiral flute design pushes chips forward out of the hole and allows the reamer to be used in holes that have an...

13mm x 1/2" Reduced Shank HSS Prentice Drill Bit DR50530

HSS 118° Degree point with 3 ground flats on the shank for no-slip chucking Black and gold surface treatment for maximum lubricity 1/2" Standard reduced shank to expand the size range capacity of...

13Pc. 1.5 - 6.5mm HSS Jobber Drill Bit Set DR06201

Available in 13, 15, 21, 25, 29, & 115 piece configurations

13Pc. 1/16 - 1/4" Cobalt Jobber Drill Bit Set DR06313

Available in 13, 15, 21, 25, 29, & 115 piece configurations