Clarkson-Osborn

11/64" HSS Chucking Reamer RE17011

HSS Bright finish Straight shank Right hand cut Straight flute Straight flute reamers are used in general purpose reaming applications in ferrous and non-ferrous materials

11/64" HSS Extra Long Drill Bit DR40211

HSS Straight shank Black oxide finish for increased wear resistance and added lubricity 118° Degree point Fractional and metric sizes in various overall lengths / flute lengths for each diameter For...

11/64" HSS Extra Long Drill Bit DR40311

HSS Straight shank Black oxide finish for increased wear resistance and added lubricity 118° Degree point Fractional and metric sizes in various overall lengths / flute lengths for each diameter For...

11/64" HSS Extra Long Drill Bit DR40411

HSS Straight shank Black oxide finish for increased wear resistance and added lubricity 118° Degree point Fractional and metric sizes in various overall lengths / flute lengths for each diameter For...

11/64" HSS Extra Long Drill Bit DR40511

HSS Straight shank Black oxide finish for increased wear resistance and added lubricity 118° Degree point Fractional and metric sizes in various overall lengths / flute lengths for each diameter For...

11/64" HSS Half Round Jobber Drill Bit DR53011

HSS Black oxide finish for increased wear resistance and added lubricity 118° Degree point These drills allow greater chip clearance and have less tendency to run out in deeper hole applications. As...

11/64" HSS Hand Reamer RE41011

HSS Right hand cut Left hand helix Bright and black finish Square end for tap wrench Hand reamers are used for the final sizing of holes Left hand spiral flute design pushes chips forward out of the...

11/64" HSS Heavy Duty Jobber Drill Bit DR74011

HSS Black oxide finish 135° Degree split point (self-centering) which eliminates "walking" and reduces the thrust force needed Heavy web construction gives this drill higher torsional strength which...

11/64" HSS Hyper Jobber Drill Bit ZD16011

HSS Black oxide finish for increased wear resistance and added lubricity 118° Degree point suitable for general purpose drilling in a wide range of materials Steam oxide surface treatment increases...

11/64" HSS Stub Drill Bit DR12011

HSS Black oxide finish for increased wear resistance and added lubricity 135° Degree split point for fast penetration and accurate starting (self-centering) which eliminates "walking" and reduces the...

11/64" HSS Taper Length Drill Bit DR20011

HSS Straight shank Black oxide finish for increased wear resistance and added lubricity 118° Degree point Taper length drills have the same flute length as taper shank drills for deeper hole...

11/64" HSS Taper Pin Reamer RE30011

HSS Bright finish ¼" taper per foot Square end for tap wrench Taper pin reamers are used to ream holes into which standard taper pins will fit Straight flute for hand reaming of most materials