Clarkson-Osborn

1-5/64" x #4 HSS Morse Taper Drill Bit DR30105

HSS 118° Degree point Black oxide finish for increased wear resistance and added lubricity Made to fit American standard (Morse) taper shank holders Recommended for general purpose use in a wide...

1-5/64" x 1/2" Reduced Shank HSS Prentice Drill Bit DR50105

HSS 118° Degree point with 3 ground flats on the shank for no-slip chucking Black and gold surface treatment for maximum lubricity 1/2" Standard reduced shank to expand the size range capacity of...

1-5/8 x 1" Cobalt Annular Cutter AC81140

Cutting lengths offered in 1", 2" 3" Annular cutters cut large diameter holes efficiently and quickly Unlike traditional twist drills, annular cutters remove only the periphery of the hole ejecting a...

1-5/8 x 1" HSS Annular Cutter AC71140

Cutting lengths offered in 1", 2" 3" Annular cutters cut large diameter holes efficiently and quickly Unlike traditional twist drills, annular cutters remove only the periphery of the hole ejecting a...

1-5/8 x 2" Cobalt Annular Cutter AC82140

Cutting lengths offered in 1", 2" 3" Annular cutters cut large diameter holes efficiently and quickly Unlike traditional twist drills, annular cutters remove only the periphery of the hole ejecting a...

1-5/8 x 2" HSS Annular Cutter AC72140

Cutting lengths offered in 1", 2" 3" Annular cutters cut large diameter holes efficiently and quickly Unlike traditional twist drills, annular cutters remove only the periphery of the hole ejecting a...

1-5/8 x 3" Cobalt Annular Cutter AC83140

Cutting lengths offered in 1", 2" 3" Annular cutters cut large diameter holes efficiently and quickly Unlike traditional twist drills, annular cutters remove only the periphery of the hole ejecting a...

1-5/8 x 3" HSS Annular Cutter AC73140

Cutting lengths offered in 1", 2" 3" Annular cutters cut large diameter holes efficiently and quickly Unlike traditional twist drills, annular cutters remove only the periphery of the hole ejecting a...

1-5/8" Arch (Wad) Punch MS10110

Used to cut perfectly round holes in soft material such as leather, plastic, rubber and card etc. Manufactured from a single drop forging, the cutting edge is hardened and ground for a long life...

1-5/8" Bright Finish HSS Stub Drill Bit DR78140

HSS Bright finish 118° Degree split point for fast penetration and accurate starting (self-centering) which eliminates "walking" and reduces the thrust force needed The short flute and overall length...

1-5/8" HSS 2 Flute Threaded Shank End Mill MC05140

HSS Center cutting Bright finish (TiN and TiCN coatings available) Designed for plunge cutting and slotting 2 flute end mills provide increased chip capacity for higher feed rates Clarkson Osborn...

1-5/8" HSS 8 Flute Threaded Shank End Mill MC03140

HSS Non center cutting Threaded shank Bright finish (TiN and TiCN coatings available) Multi-flute design reduces chip load per tooth, has greater wear resistance, and improved surface finish Designed...