Clarkson-Osborn

1-3/8 x 2" HSS Annular Cutter AC72124

Cutting lengths offered in 1", 2" 3" Annular cutters cut large diameter holes efficiently and quickly Unlike traditional twist drills, annular cutters remove only the periphery of the hole ejecting a...

1-3/8 x 3" Cobalt Annular Cutter AC83124

Cutting lengths offered in 1", 2" 3" Annular cutters cut large diameter holes efficiently and quickly Unlike traditional twist drills, annular cutters remove only the periphery of the hole ejecting a...

1-3/8 x 3" HSS Annular Cutter AC73124

Cutting lengths offered in 1", 2" 3" Annular cutters cut large diameter holes efficiently and quickly Unlike traditional twist drills, annular cutters remove only the periphery of the hole ejecting a...

1-3/8" Arch (Wad) Punch MS10106

Used to cut perfectly round holes in soft material such as leather, plastic, rubber and card etc. Manufactured from a single drop forging, the cutting edge is hardened and ground for a long life...

1-3/8" Bright Finish HSS Stub Drill Bit DR78124

HSS Bright finish 118° Degree split point for fast penetration and accurate starting (self-centering) which eliminates "walking" and reduces the thrust force needed The short flute and overall length...

1-3/8" Cobalt 6 Flute Threaded Shank End Mill MC33124

Cobalt Non-center cutting Bright finish (TiN and TiCN coatings available) Multi-flute design reduces chip load per tooth, has greater wear resistance, and improved surface finish Designed for...

1-3/8" Cobalt 6 Flute Threaded Shank Roughing End Mill MC36124

Cobalt Non-center cutting Bright finish (TiN and TiCN coatings available) Truncated knuckle form reduces drag and friction Chip breaker cutting edge allows for heavier cuts and higher speeds / feeds...

1-3/8" HSS 2 Flute End Mill EM50688

HSS Center cutting Bright finish (TiN and TiCN coatings available) Designed for plunge cutting and slotting Clarkson Osborn Catalog

1-3/8" HSS 2 Flute Long Threaded Shank End Mill MC06124

HSS Center cutting Longer overall length / length of cut Bright finish (TiN and TiCN coatings available) Designed for plunge cutting and slotting 2 flute end mills provide increased chip capacity for...

1-3/8" HSS 2 Flute Threaded Shank End Mill MC05124

HSS Center cutting Bright finish (TiN and TiCN coatings available) Designed for plunge cutting and slotting 2 flute end mills provide increased chip capacity for higher feed rates Clarkson Osborn...

1-3/8" HSS 4 Flute Threaded Shank Corner Rounding Cutter MC15032

HSS Four flute Designed for milling rounded corners on various materials Clarkson Osborn Catalog

1-3/8" HSS 6 Flute End Mill EM60588

HSS Non-center cutting Bright finish (TiN and TiCN coatings available) Multi flute design reduces chip load per tooth, offer greater wear resistance, and improved surface finish Designed for profile,...