Clarkson-Osborn

1-3/4" HSS 6 Flute Long End Mill EM62712

HSS Non-center cutting Bright finish (TiN and TiCN coatings available) Longer overall length / length of cut Multi-flute design reduces chip load per tooth, offer greater wear resistance, and...

1-3/4" HSS 8 Flute Long Threaded Shank End Mill MC04148

HSS Non-center cutting Bright finish (TiN and TiCN coatings available) Longer overall length / length of cut Multi-flute design reduces chip load per tooth, has greater wear resistance, and improved...

1-3/4" HSS 8 Flute Threaded Shank End Mill MC03148

HSS Non center cutting Threaded shank Bright finish (TiN and TiCN coatings available) Multi-flute design reduces chip load per tooth, has greater wear resistance, and improved surface finish Designed...

1-3/4" HSS 8 Flute Threaded Shank End Mill MC03448

HSS Non center cutting Threaded shank Bright finish (TiN and TiCN coatings available) Multi-flute design reduces chip load per tooth, has greater wear resistance, and improved surface finish Designed...

1-3/4" HSS Hand Reamer RE41148

HSS Right hand cut Left hand helix Bright and black finish Square end for tap wrench Hand reamers are used for the final sizing of holes Left hand spiral flute design pushes chips forward out of the...

1-3/4" HSS Taper Length Drill Bit DR20148

HSS Straight shank Black oxide finish for increased wear resistance and added lubricity 118° Degree point Taper length drills have the same flute length as taper shank drills for deeper hole...

1-3/4" TiCN Coated Cobalt 2 Flute Keyway Tolerance End Mill EM01148C

Cobalt Center cutting Bright finish (TiN and TiCN coating available) Keyway tolerance end mills have the same design as regular 2 flute but are held to a mill diameter tolerance of +.0000 - .0015"...

1-3/4" TiCN Coated Cobalt 6 Flute Long Threaded Shank Roughing End Mill MC37448C

Cobalt Non-center cutting Bright finish (TiN and TiCN coatings available) Longer overall length / length of cut Truncated knuckle form reduces drag and friction Chip breaker cutting edge allows for...

1-3/4" TiCN Coated Cobalt 6 Flute Threaded Shank Roughing End Mill MC36448C

Cobalt Non-center cutting Bright finish (TiN and TiCN coatings available) Truncated knuckle form reduces drag and friction Chip breaker cutting edge allows for heavier cuts and higher speeds / feeds...

1-3/4" TiCN Coated HSS 2 Flute End Mill EM50712C

HSS Center cutting Bright finish (TiN and TiCN coatings available) Designed for plunge cutting and slotting Clarkson Osborn Catalog

1-3/4" TiCN Coated HSS 2 Flute High Helix Ball Nose End Mill EM18148C

HSS Center cutting Bright finish (TiN and TiCN coatings available) High helix geometry is ideally suited for softer non-ferrous materials such as aluminum, zinc, magnesium This helix angle results in...

1-3/4" TiCN Coated HSS 2 Flute High Helix End Mill EM15148C

HSS Center cutting Bright finish (TiN and TiCN coatings available) High helix geometry is ideally suited for softer non-ferrous materials such as aluminum, zinc, magnesium This helix angle results in...